Introduction

Dissembly to replace/repair optical drive.

Unplug all the cables from the computer, including the power cable. Lay the computer face-down, supporting the neck and base with a soft cloth under the screen.
  • Unplug all the cables from the computer, including the power cable. Lay the computer face-down, supporting the neck and base with a soft cloth under the screen.

Ajouter un commentaire

Loosen the four Phillips #0 screws.
  • Loosen the four Phillips #0 screws.

Ajouter un commentaire

  • Carefully remove the base access panel.

Ajouter un commentaire

  • Remove the four 25mm T-15 screws.

Ajouter un commentaire

  • Open the housing plate.

  • Be gentle with the wires still connected to the logic board so as not to ruin the cables.

  • A fixed plug connector between the logic board and upper unit will cause some resistance. Pull gently but firmly.

Ajouter un commentaire

  • Remove the 2 torx 10mm screws on the EMI shield

  • Carefully remove shield and copper tape

Ajouter un commentaire

  • Remove the 4 10mm torx screws attatched to the drive carrier.

  • The drive carrier includes optical drive and hard drive.

Ajouter un commentaire

  • Grasp the carrier with both hands on each side.

  • Remove the carrier by lifting up and out.

  • Pull gently but firmly. The carrier is meant to fit snugly.

Ajouter un commentaire

  • Flip the removed carrier to the right and pull out power cables.

Ajouter un commentaire

  • Peel back the white paper, revealing the screws that connect the hard drive to the carrier.

  • Remove the 4 T-10 5mm screws connecting the hard drive and frame. (There are 2 screws on each side)

Ajouter un commentaire

  • Slide the hard drive out from the frame and optical drive.

Ajouter un commentaire

  • Remove the four T-10 6mm screws at the sides of the drive.

Ajouter un commentaire

  • Slide the optical drive out of the carrier

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

5 autre(s) ont terminé cette réparation.

Courtney

Membre depuis le 06/10/2011

734 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 21-22, Maness Fall 2011 Membre de l'équipe Cal Poly, Team 21-22, Maness Fall 2011

CPSU-MANESS-F11S21G22

4 membres

13 tutoriels rédigés

Should step ten of removing the optical drive be broken into two different steps

David Hunter - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 12

Total : 3,103