Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Boutique

Pièces

Aucune pièce spécifiée.

  1. Disconnect the hard drive thermal sensor by pulling the connector away from its socket parallel to the face of the hard drive.
    • Disconnect the hard drive thermal sensor by pulling the connector away from its socket parallel to the face of the hard drive.

  2. Pressing the top of the hard drive bracket down to release it from the rear case requires a substantial amount of force, so we recommend laying your iMac stand-side down on a table to avoid knocking it over. Press the hard drive bracket down toward the bottom edge of your iMac to free it from the rear case, then rotate the top of the drive toward yourself.
    • Pressing the top of the hard drive bracket down to release it from the rear case requires a substantial amount of force, so we recommend laying your iMac stand-side down on a table to avoid knocking it over.

    • Press the hard drive bracket down toward the bottom edge of your iMac to free it from the rear case, then rotate the top of the drive toward yourself.

    • Lift the hard drive off its lower pins and pull it out of the rear case, minding the cables that are still attached.

    • When reinstalling the hard drive, be careful not to push the rubber grommets through the chassis with the hard drive pins as retrieving them may require logic board removal.

  3. SAUTEZ LA MISE À NIVEAU

    Économisez en réparant avec un kit tout-en-un.

    Fix Kits pour iPhone

    SAUTEZ LA MISE À NIVEAU

    Économisez en réparant avec un kit tout-en-un.

    Fix Kits pour iPhone
  4. Insert the flat end of a spudger into the gap between the SATA power connector and the hard drive. Twist the spudger to separate the SATA power connector from the hard drive.
    • Insert the flat end of a spudger into the gap between the SATA power connector and the hard drive.

    • Twist the spudger to separate the SATA power connector from the hard drive.

    • Pull the SATA power connector away from the hard drive.

  5. Pull the SATA data cable away from the hard drive.
    • Pull the SATA data cable away from the hard drive.

    • Hard drive remains.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 532