Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
-
Collez une ventouse sur chacun des deux angles supérieurs de la vitre.
-
Si la ventouse n'adhère pas à la vitre, essayez de les nettoyer, l'une et l'autre, à l'aide d'un solvant doux.
-
-
-
Retirez les deux vis Torx T10 8 mm par lesquelles l'écran est fixé au boîtier extérieur.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the two 9 mm T10 Torx screws securing the LED driver board to the outer case.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Lift the LED driver board out of its recess in the outer case, minding the DC-In cable still attaching it to the power supply.
-
Disconnect the DC-In cable by depressing the locking mechanism while pulling the connector away from its socket on the LED driver board.
-
Annulation : je n'ai pas terminé ce tutoriel.
2 autres ont terminé cette réparation.
6 commentaires
Same question as above, how to check if it's power board or LED driver board that is damaged?
It might not be a complete answer but I had to change my LED Driver Board when my display went black ( as if the computer was in sleep mode ) as soon as the computer was on. I had to push the power button to get the screen back multiple time. There was also a problem with the graphic card but even after changing the GC, the screen would go black. We figure it was the LED Driver Board when we realized the computer wouldn’t show anything on an external monitor. Hope it helps :)
I have the same problem Mary. The imac starts but no screen and i need to shut down/turn on a few times until i see the normal screen. Very ocassionally the screen blinks too or turns to black and i can only see stuff by flashing a light to the LCD. Where did you buy the LED Driver Board?? Can’t find it anywhere..