Aller au contenu principal

Introduction

Internal Prerequisite.

  1. Remove the strip of tape securing the GPU thermal sensor cable to the logic board.
    • Remove the strip of tape securing the GPU thermal sensor cable to the logic board.

  2. Remove the following three screws:
    • Remove the following three screws:

    • One 4.2 mm T10 Torx screw

    • Two 5 mm T8 Torx screws

  3. Grab the GPU thermal sensor cable connector and pull it straight up and out of its socket on the logic board. Do not pull the connector out by its cables.
    • Grab the GPU thermal sensor cable connector and pull it straight up and out of its socket on the logic board.

    • Do not pull the connector out by its cables.

  4. Lift the GPU heat sink slightly and pull the GPU board out of its socket on the logic board.
    • Lift the GPU heat sink slightly and pull the GPU board out of its socket on the logic board.

Conclusion

To reassemble your device, follow these instructions in reverse order.

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 1

Total : 519