Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
-
Collez une ventouse sur chacun des deux angles supérieurs de la vitre.
-
Si la ventouse n'adhère pas à la vitre, essayez de les nettoyer, l'une et l'autre, à l'aide d'un solvant doux.
-
-
-
Retirez les huit vis Torx T10 8 mm par lesquelles l'écran est fixé au boîtier extérieur.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the flat end of a spudger to pry the Bluetooth antenna cable connector up from its socket on the Bluetooth board.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the single 6.6 mm T8 Torx screw securing the Bluetooth board to the outer case.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the piece of tape wrapped around the Bluetooth board.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Disconnect the Bluetooth cable by pulling its connector away from the socket on the Bluetooth board.
-
Remove the Bluetooth board from your iMac.
-
Annulation : je n'ai pas terminé ce tutoriel.
5 autres ont terminé cette réparation.
2 commentaires
Seriously this is so incomplete! What about the cable that connects the Bluetooth to the logic board!?!??? Like this is so half way explanatory!
it is much easier to replace the bluetooth board if you first remove the glass panel, then remove the 8 screws from the display and carefully lift it about 7-8cm without detaching the cables. With the top of the iMac facing towards you, fix the position of the display with something like a thick book and you should be able to remove and replace the bluetooth board easily.