Aller au contenu principal

Pièces

Aucune pièce spécifiée.

  1. Cracked near home button its important to not break home button flex cable Apply heat to the screen! Do NOT SKIP THIS STEP
    • Cracked near home button its important to not break home button flex cable

    • Apply heat to the screen! Do NOT SKIP THIS STEP

    • Make sure to turn it off if you can to prevent breaking the backlight filter

    • Pry with splicer around the edges

    • Display cables are on the bottom of screen opening up like an upside-down note pad

  2. Lift from the top like so
    • Lift from the top like so

    • Display Cables

  3. Set screen up a little bit to get to power connection Power connection has PH000 screw holding it together Slide a card under connection
    • Set screen up a little bit to get to power connection

    • Power connection has PH000 screw holding it together

    • Slide a card under connection

    • Its very important to disconnect battery try turning it on make sure it is off to avoid further damage to ipad

  4. Lift display back up to get to the display cables Unscrew 2 PH000 Screws from display cable bracket
    • Lift display back up to get to the display cables

    • Unscrew 2 PH000 Screws from display cable bracket

    • Use the flat end of plastic spudger to lift off connections

    • There is 4 flex cables that need disconnecting

  5. Whoohoo we got it off now clean the edges for any broken glass Keep track of rubbers covering proximity light sensor on the top Light covers  place on top of proxmity sensors
    • Whoohoo we got it off now clean the edges for any broken glass

    • Keep track of rubbers covering proximity light sensor on the top

    • Light covers place on top of proxmity sensors

  6. APPLY HEAT TO HOME BUTTON 15-20 Seconds should do the trick If heat is not applied you might break the home button along with the touch ID. If you replace the home button touch ID will not work anymore Take of home button flex cover
    • APPLY HEAT TO HOME BUTTON 15-20 Seconds should do the trick

    • If heat is not applied you might break the home button along with the touch ID. If you replace the home button touch ID will not work anymore

    • Take of home button flex cover

    • Use flat end of spudger to pry up home button flex connector

  7. Reapply heat if you spent to much time getting flex unhooked Pry with splicer under the home button bracket car Clean glass around gasket
    • Reapply heat if you spent to much time getting flex unhooked

    • Pry with splicer under the home button bracket car

    • Clean glass around gasket

  8. Install home button on new screen I recommend using liquid adhesive for this! Push the home button a couple of times to make sure it stills on and make sure it is clicking!
    • Install home button on new screen I recommend using liquid adhesive for this!

    • Push the home button a couple of times to make sure it stills on and make sure it is clicking!

  9. Connect all 4 Flex cables to the logic board! Now at the bottom of the new screen screw in the battery connection to test the new screen!
    • Connect all 4 Flex cables to the logic board!

    • Now at the bottom of the new screen screw in the battery connection to test the new screen!

  10. Test screen drawing on the notes make sure it works!
    • Test screen drawing on the notes make sure it works!

    • Adhere new screen with preinstalled adhesive and clap it!

Ligne d'arrivée

Une autre personne a terminé cette réparation.

Mark D Schlossman

Membre depuis le 25/09/2019

3 585 Réputation

8 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 9

Total : 90