Aller au contenu principal

Introduction

Use this guide to remove or replace the two screws securing the iPhone 12 Pro display panel. These are the only screws on the exterior of the iPhone. They use a five-point design that is unique to Apple, requiring a specialty P2 pentalobe driver for removal.

Pièces

Aucune pièce spécifiée.

  1. Caution: Before you begin, discharge your iPhone battery below 25%. A charged lithium-ion battery can catch fire and/or explode if accidentally punctured.
    • Caution: Before you begin, discharge your iPhone battery below 25%. A charged lithium-ion battery can catch fire and/or explode if accidentally punctured.

    • Power off your iPhone before beginning disassembly.

    • Remove the two 6.75 mm long pentalobe P2 screws at the bottom edge of the iPhone.

    • Opening the iPhone's display will compromise its waterproof seals. Have replacement seals ready before you proceed past this step, or take care to avoid liquid exposure if you reassemble your iPhone without replacing the seals.

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autres ont terminé cette réparation.

Adam O'Camb

Membre depuis le 11/04/2015

140 305 Réputation

407 tutoriels rédigés

Équipe

iFixit Membre de l'équipe iFixit

Community

138 membres

16 442 tutoriels rédigés

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 3

7 derniers jours : 24

30 derniers jours : 47

Total : 354