Réparez vos affaires Communauté Boutique

iPhone 6 Plus Antenna Assembly Replacement

Conditions préalables uniquement
Ce tutoriel est uniquement destiné à être utilisé comme prérequis d'autres tutoriels. Il ne se suffit pas à lui-même.

Introduction

Prereq only, battery removed, rear camera removed, logic board will be removed.

Ce dont vous avez besoin

  1. iPhone 6 Plus Antenna Assembly Replacement, Antenna Assembly: étape 1, image 1 de 1

    • Remove the following screws securing the antenna bracket to the rear case:

    • One 1.5 mm Phillips #00 screw

    • One 2.8 mm Phillips #00 screw

    Modifier

  2. iPhone 6 Plus Antenna Assembly Replacement: étape 2, image 1 de 1
    Outil utilisé dans cette étape :
    Tweezers
    $4.99
    J'achète

    • Grasp the antenna bracket with a pair of tweezers and lift it off the iPhone.

    Modifier

  3. iPhone 6 Plus Antenna Assembly Replacement: étape 3, image 1 de 1

    • Carefully pry the antenna connector up off the logic board with a plastic opening tool.

    Modifier

  5. iPhone 6 Plus Antenna Assembly Replacement: étape 4, image 1 de 2 iPhone 6 Plus Antenna Assembly Replacement: étape 4, image 2 de 2

    • Grasp the antenna connector with a pair of tweezers and gently lift it from its retaining clip on the logic board.

    Modifier

  6. iPhone 6 Plus Antenna Assembly Replacement: étape 5, image 1 de 2 iPhone 6 Plus Antenna Assembly Replacement: étape 5, image 2 de 2

    • The two connectors may be coupled by a single adhesive tab. If this is the case, then they may detach as a pair.

    • Disconnect the power button cable and audio control cable connectors from their respective sockets on the logic board.

    Modifier

  7. iPhone 6 Plus Antenna Assembly Replacement: étape 6, image 1 de 1

    • Remove the following screws securing the top cellular antenna to the rear case:

    • One 2.8 mm Phillips #00 screw

    • Two 1.6 mm Phillips #00 screws

    Modifier

  8. iPhone 6 Plus Antenna Assembly Replacement: étape 7, image 1 de 2 iPhone 6 Plus Antenna Assembly Replacement: étape 7, image 2 de 2

    • Use a pair of tweezers to grasp and remove the top cellular antenna out of the iPhone.

    • During reassembly, make sure to place the small washer in the top left corner of the antenna assembly.

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 1

7 derniers jours : 2

30 derniers jours : 2

Total : 679