Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Lift the battery up from the adhesive holding it to the iPod.
-
Lay the battery next to the iPod (it is still connected to the logic board).
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Carefully disconnect the orange ribbon cable from the hard drive.
-
If the cable doesn't come free easily, it may be helpful to gently wiggle the cable from side to side.
-
Lift the hard drive out of the iPod.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Carefully disconnect the white battery connector from the logic board. Be sure to pull only on the connector itself and not on the cables.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Peel up the gray rubber bumper near the hard drive ribbon to reveal the T6 Torx screw beneath.
-
Remove the newly revealed T6 Torx screw.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the 3 remaining T6 Torx screws from the logic board.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Slide the logic board away from the port end of the casing and lift it out of the iPod.
-
Annulation : je n'ai pas terminé ce tutoriel.
3 autres ont terminé cette réparation.