Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
Outil utilisé dans cette étape :Jimmy$7.95-
Carefully insert a small flathead screwdriver or Jimmy in the seam between the metal casing and white plastic top. Use the screwdriver to pry up the white plastic top bezel. Be careful not to damage the soft plastic with your screwdriver.
-
To make this job easier, heat up the adhesive with a hairdryer on low heat for a few seconds.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
Outil utilisé dans cette étape :Jimmy$7.95-
Carefully insert a small flathead screwdriver or Jimmy in the seam between the metal casing and white plastic bottom Use the screwdriver to pry up the white plastic bottom bezel. Be careful not to damage the soft plastic with your screwdriver.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
A small pair of snap ring pliers is the easiest tool to remove the metal retaining bracket.
-
You can also use a flathead screwdriver to pry out the metal retaining bracket beneath the bottom bezel as shown. You can free the bracket by first pushing in the metal arms on the corners and then lifting the bracket.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Lift the metal retaining bracket out of the iPod.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use a spudger or the tip of your finger to carefully disconnect the orange click wheel ribbon from the logic board.
-
Careful not to dig the spudger in too deep to avoid detaching the contact on the logic board. Try to keep the spudger as close to the orange click wheel ribbon connector as possible.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the two #00 Phillips screws securing the headphone jack to the casing.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Carefully slide the iPod out of its casing by pushing on the logic board near the bottom edge of the click wheel.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
After pushing the logic board out sufficiently, gently grasp the logic board on either side of the display, and continue to slide the iPod out of its casing.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Lift the battery off of the logic board and lay it to the side of the iPod.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Carefully disconnect the battery from the logic board. Make sure to pull only on the connector and not on the battery wires.
-
Annulation : je n'ai pas terminé ce tutoriel.
356 autres ont terminé cette réparation.
28 commentaires
i cant seem to slide it away from the casing, im pushing on the charger port and no movement what so ever
Maybe the metal is bent, or the plastic on the top of the unit is somehow stuck. I'd look for a bend or disfigured metal, though.
nclee -
@mrmacfixit you must have. If it's the same voltage as the old battery, it will work, but you DON'T want to risk puncturing it forcing it into the case.