Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Insert the large iPod opening tool into the seam between the front case and rear panel of the iPod, below the dock connector. Run the tool back and forth to create an opening. The tool's edge should point toward the rear panel to prevent any accidental scratching of the aluminum front case.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Insert a small iPod opening tool into the seam on the Hold button side of the iPod, with the edge of the tool pointing toward the rear panel.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Gently enlarge the existing gap by pressing/wiggling the small iPod opening tool into the gap near each of the two tabs attached to the rear case, pushing the clips toward the center of the iPod until both have been freed.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Repeat the same procedure listed in the previous step to free the five clips along the headphone jack side of the iPod.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
After ensuring all tabs are free, separate the two halves of the iPod.
-
The rear panel is now free from the iPod.
-
Annulation : je n'ai pas terminé ce tutoriel.
19 autres ont terminé cette réparation.