Introduction

The metal bracket within your iPod.

Before opening your iPod, ensure that the hold switch is in the locked position.
  • Before opening your iPod, ensure that the hold switch is in the locked position.

Ajouter un commentaire

When removing the the bottom bezel, be sure not to bend the plastic surrounding the dock connector.
  • When removing the the bottom bezel, be sure not to bend the plastic surrounding the dock connector.

  • Carefully insert an iPod opening tool in the seam between the metal casing and white plastic bezel

  • Lift the bottom bezel off the iPod. It's glued on using a mild adhesive, so some force may be required.

Ajouter un commentaire

  • Remove the following two screws:

    • One #00 Phillips screw with a large head near the headphone jack.

    • One #00 Phillips screw with a smaller head near the side of the iPod. This screw strips easily, so be sure to press down firmly on the screwdriver.

Ajouter un commentaire

  • Use a metal spudger to carefully pry the headphone jack out of the casing. DO NOT remove the headphone jack from the iPod entirely, as it is connected via a fragile ribbon connector to the click wheel.

Ajouter un commentaire

  • Slide the headphone jack out until the white plastic housing is no longer held in place by the metal casing.

Ajouter un commentaire

  • Remove the newly-revealed Phillips #00 screw from beneath the headphone jack.

Ajouter un commentaire

  • Lift the bottom bezel bracket out of the iPod.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

7 autre(s) ont terminé cette réparation.

iRobot

Membre depuis le 24/09/2009

1 Réputation

774 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 4

30 derniers jours : 22

Total : 16,245