Introduction

Replace that faulty logic board to restore functionality to a broken iPod Shuffle.

  1. Widen the small gap between the front and rear case by inserting a metal spudger into the gap near the top of the iPod.
    • Widen the small gap between the front and rear case by inserting a metal spudger into the gap near the top of the iPod.

    • Be careful when using a metal spudger, as you may scratch the outer case.

    Ajouter un commentaire

  2. Insert an iPod opening tool into the newly widened gap, and pry the rear case up and away from the front case.
    • Insert an iPod opening tool into the newly widened gap, and pry the rear case up and away from the front case.

    Ajouter un commentaire

    • Insert the iPod Shuffle opening tool into the gap between the front and rear case on the same side, at the bottom corner of the iPod.

    • Pry the rear case away from the front case.

    Ajouter un commentaire

    • Lift the bottom of the rear case and remove it from the rest of the iPod.

    Ajouter un commentaire

    • Disconnect the headphone jack and shuffle switch connector by prying it off the logic board with a spudger.

    Ajouter un commentaire

    • Remove the single Phillips screw securing the logic board to the front case.

    Ajouter un commentaire

    • Peel the battery up from the front case with an iPod opening tool.

    • Remove the logic board and battery from the iPod.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Matthew Newsom

Membre depuis le 05/01/2010

31 873 Réputation

67 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 9

Total : 5,827