Aller au contenu principal

Introduction

This guide will help you in identifying the soldering joints locations for the loud speaker on the iPod Touch 4th Generation

  1. I've boxed where the ribbon cable connectors go for the screen and camera. The soldering joints are marked with a Blue and a Red dot to indicate where to solder the speaker wires.
    • I've boxed where the ribbon cable connectors go for the screen and camera.

    • The soldering joints are marked with a Blue and a Red dot to indicate where to solder the speaker wires.

    • The second picture shows the wires soldered to the logic board.

    • The loud speaker replacement was very tedious job.. anyways Good Luck

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 autres ont terminé cette réparation.

Tysl332

Membre depuis le 11/02/2014

289 Réputation

1 tutoriel rédigé

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 2

7 derniers jours : 7

30 derniers jours : 17

Total : 6,419