Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the 4mm flathead screw on the battery cover.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Eight Phillips screws are located underneath the stickers.
-
Carefully cut around the 8 screw holes using an X-acto knife or razor blade to reveal the screws.
-
Remove the screws with a #2 Phillips screwdriver.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
With the device upside down, pull up to separate the bottom from the top cover.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Locate the three arrows on each wheel.
-
Insert metal spudger at arrow locations to pop off the wheel covers.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use blunt nose pliers to remove circlip.
-
Once clip is removed you can pull the wheel off in an outward motion.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove two #1 Phillips screws.
-
Pull off sprocket.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove four #2 Phillips and lift off retainer.
-
Pull out all weights and set aside
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Using the blunt nose pliers, peel up the adhesive and feed the wires with adhesive through the opening.
-
Annulation : je n'ai pas terminé ce tutoriel.
Une autre personne a terminé cette réparation.
2 commentaires
Nice! Very helpful.
Popping the wheel covers as shown breaks the small hooks that hold the wheel cover on. You need to rotate the cover clock wise to release them. There probably is a special tool that uses the small impressions in the cover.