Introduction

This guide explains how to remove the brush case from your Roomba.

Pièces

Aucune pièce nécessaire.

Place your Roomba upside-down on a hard surface.
  • Place your Roomba upside-down on a hard surface.

If all you need off is the faceplate, skip all of the screwdriver-based steps, and just remove the dirt bin(step 7) and start from step 11 at the rear.

David Forrest - Réponse

While holding the side brush in place, use a Phillips #1 screwdriver to remove the 4.5mm screw from the center of the brush.
  • While holding the side brush in place, use a Phillips #1 screwdriver to remove the 4.5mm screw from the center of the brush.

Ajouter un commentaire

  • Gently pull upwards on the brush to remove it.

Ajouter un commentaire

  • Rotate the Roomba upside-down so the bottom is facing towards you.

Ajouter un commentaire

  • Using a Phillips #2 screwdriver, remove the captive screws that hold the bottom plate in place.

Ajouter un commentaire

  • Carefully lift the bottom plate.

  • The battery is only secured in place by the bottom plate, and may fall out once the bottom plate is removed.

Ajouter un commentaire

  • Push on the dirt bin release button, and pull gently.

Might as well do this first, so you don’t dump dirt everywhere when flipping Roomba over.

maccentric - Réponse

  • Use a Phillips #1 screwdriver to loosen the 4 captive screws around the case .

Ajouter un commentaire

  • Grab the brush case and pull upwards to remove.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

John McTigue

Membre depuis le 31/01/2014

331 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 13-14, Regan Winter 2014 Membre de l'équipe Cal Poly, Team 13-14, Regan Winter 2014

CPSU-REGAN-W14S13G14

4 membres

13 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 4

Total : 474