Introduction

This guide explains how to remove the brushes from your iRobot Roomba 551, either for replacement or cleaning.

Pièces

Aucune pièce nécessaire.

  1. Place your Roomba upside-down on a hard surface.
    • Place your Roomba upside-down on a hard surface.

  2. While holding the side brush in place, use a Phillips #1 screwdriver to remove the 4.5mm screw from the center of the brush.
    • While holding the side brush in place, use a Phillips #1 screwdriver to remove the 4.5mm screw from the center of the brush.

  3. Gently pull upwards on the brush to remove it.
    • Gently pull upwards on the brush to remove it.

  4. %Livraison gratuite pour toute commande supérieure à 100,00 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique

    Avez-vous jamais réparé quelque chose ? C’est génial.

    Share your repair story with #ImAGenius

    Nous sommes tous des génies

    Share your repair story with #ImAGenius

  5. Rotate the Roomba upside-down so the bottom is facing towards you.
    • Rotate the Roomba upside-down so the bottom is facing towards you.

  6. Using a Phillips #2 screwdriver, remove the captive screws that hold the bottom plate in place. Using a Phillips #2 screwdriver, remove the captive screws that hold the bottom plate in place.
    • Using a Phillips #2 screwdriver, remove the captive screws that hold the bottom plate in place.

  7. Carefully lift the bottom plate.
    • Carefully lift the bottom plate.

    • The battery is only secured in place by the bottom plate, and may fall out once the bottom plate is removed.

  8. Pinch the yellow tabs on the sides of the brush cage and lift up to open. Pinch the yellow tabs on the sides of the brush cage and lift up to open.
    • Pinch the yellow tabs on the sides of the brush cage and lift up to open.

  9. Grab each brush and lift upwards to remove. Grab each brush and lift upwards to remove. Grab each brush and lift upwards to remove.
    • Grab each brush and lift upwards to remove.

Conclusion

To reassemble your device, follow these instructions in reverse order.

John McTigue

Membre depuis le 31/01/2014

331 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 13-14, Regan Winter 2014 Membre de l'équipe Cal Poly, Team 13-14, Regan Winter 2014

CPSU-REGAN-W14S13G14

4 membres

13 tutoriels rédigés

Should be no need to remove the back plate. Just open the brush cage and lift out the brushes

Gunnar Nybraten - Réponse

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 2

30 derniers jours : 6

Total : 992