Introduction
This easy to follow guide will walk you through replacing a defective side brush module on your roomba. This guide requires a propriatery bit screwdriver that is not found in most homes. You will need to purchase one before begining.
Ce dont vous avez besoin
-
-
Start by flipping your Roomba onto its back on a flat surface.
Demander à FixBot
-
-
-
Unscrew both the 11mm Phillips #2 screws from the battery cover and remove cover from the Roomba.
-
-
-
Grasp the tabs on either side of the battery.
-
Remove the battery by pulling up on the tabs.
-
While you're here, check the battery contacts for corrosion or debris.
-
-
-
-
Remove the 7.5mm flat head #4 screw from center of the side brush.
-
-
-
Unscrew 2 phillips #2 screws from the bottom cover.
-
Remove the bottom cover.
-
-
-
Unscrew and remove the single 13mm Tri-point Y1 screw and retaining tab.
-
Loosen two captive Phillips #00 16mm screws.
-
To reassemble your device, follow these instructions in reverse order.
Équipe
South Arkansas Community College, Team S1-G1, Mitchell Summer 2019 Membre de l'équipe South Arkansas Community College, Team S1-G1, Mitchell Summer 2019
SACC-MITCHELL-SU19S1G1
2 membres
5 tutoriels rédigés
1 commentaire de tutoriel
We did this whole process and it still doesn’t turn :0(
