Aller au contenu principal

Info : Vous modifiez actuellement une condition préalable du tutoriel que vous venez de consulter. Toutes les modifications affecteront les 2 tutoriels qui comprennent cette étape.

Anglais
Chinois

Traduction de l’étape 3

Étape 3
Try to keep the adhesive strips flat and unwrinkled during this procedure; twisted or wrinkled strips will stick together and break instead of pulling out cleanly. Additionally, do not press down on the battery as you pull the strips. Pressing on the battery creates pressure points that can snag and break the adhesive. Slowly pull one battery adhesive tab away from the battery, towards the bottom of the iPhone.
  • Try to keep the adhesive strips flat and unwrinkled during this procedure; twisted or wrinkled strips will stick together and break instead of pulling out cleanly.

  • Additionally, do not press down on the battery as you pull the strips. Pressing on the battery creates pressure points that can snag and break the adhesive.

  • Slowly pull one battery adhesive tab away from the battery, towards the bottom of the iPhone.

  • Pull steadily, maintaining constant tension on the strip until it slips out from between the battery and the rear case. For best results, pull the strip at as low an angle as possible, without snagging it on any of the iPhone's other components.

  • The strip will stretch to many times its original length. Continue pulling and re-grab the strip near the battery if necessary.

  • If the battery adhesive tabs break during the removal process, use your fingers or blunt tweezers to retrieve the remaining length of adhesive, and continue pulling.

  • If any of the adhesive strips break underneath the battery and cannot be retrieved, try to remove the remaining strips, and then proceed as instructed below.

在此过程中尽量保持胶条平整无皱; 扭曲或起皱的条带可能会无法完全从电池下方拉出。

此外,拉动条带时请勿按压电池。 按压电池会产生压力,从而阻碍胶带与电池分离。

朝向iPhone底部慢慢的拉动胶带拉手使胶带与电池分离。

稳稳地拉动,保持胶条上的张力均匀,直到胶条从电池和后壳之间滑出。 为获得最佳效果,请尽可能以较低的角度拉动胶条,而不要将其挂在任何iPhone的其他组件上。

胶条将拉伸至其原始长度的许多倍。 如有必要,继续拉动并重新抓住靠近电池边的胶条。

如果在拆卸过程中电池胶条断裂,请用手指或钝镊子拿出剩下的胶条,然后继续拉动。

如果胶条在电池下方破裂进而无法取出,请尝试取下剩余的胶条,然后按照下面的说明进行操作。

Vos contributions sont faites dans le cadre de la licence open source Creative Commons.