Aller au contenu principal

Info : Vous modifiez un tutoriel prérequis. Toutes les modifications apportées affecteront les 6 tutoriels qui comprennent cette étape.

Anglais
Espagnol

Traduction de l’étape 1

Étape 1
Before starting this process it's important to note that the eMac can have some seriously dangerous voltages inside of it, thanks to the CRT display. Before working on an eMac, you should unplug it, press the power button to clear any stored charge on the motherboard, and then let it sit for 24-hours (or more) to allow the CRT to discharge.
Bottom Screw Removal
  • Before starting this process it's important to note that the eMac can have some seriously dangerous voltages inside of it, thanks to the CRT display. Before working on an eMac, you should unplug it, press the power button to clear any stored charge on the motherboard, and then let it sit for 24-hours (or more) to allow the CRT to discharge.

  • You can read more about CRT safety procedures here. If you aren't experienced with working on devices featuring a CRT, it's recommended that you don't proceed any further.

  • On the bottom side of the eMac, remove the following screws:

  • A single 2.5mm hex screw

  • Two #2 phillips screws

Antes de comenzar este proceso, es importante saber que el eMac puede tener voltajes muy peligrosos dentro, gracias a la pantalla CRT. Antes de trabajar en él, desenchúfalo, pulsa el botón de encendido para eliminar cualquier carga almacenada en la placa base y luego dejarlo reposar durante 24 horas (o más) para permitir que se descargue el CRT.

Puedes leer más sobre los procedimientos de seguridad de CRT aquí. Si no tienes experiencia trabajando en dispositivos con CRT, se recomienda que no continúes.

En la parte inferior del eMac, quita los siguientes tornillos:

Un solo tornillo hexagonal de 2.5 mm

Dos tornillos Phillips #2

Vos contributions sont faites dans le cadre de la licence open source Creative Commons.