Aller au contenu principal

Samsung Galaxy S8+ Glasrückseite ersetzen

Info : Vous modifiez un tutoriel prérequis. Toutes les modifications apportées affecteront les 5 tutoriels qui comprennent cette étape.

Anglais
Allemand

Traduction de l’étape 3

Étape 3
Samsung Galaxy S8+ Back Glass Replacement: étape 0, image 1 de 2 Samsung Galaxy S8+ Back Glass Replacement: étape 0, image 2 de 2
  • Secure a suction cup to the back cover, as close to the heated edge as possible.

  • The suction cup will not make a good seal on the curved portion of the glass, so avoid putting it on the very edge.

  • If the phone's back cover is cracked, the suction cup may not stick. Try lifting it with strong tape, or superglue the suction cup in place and allow it to cure so you can proceed.

  • Lift the back cover's left edge with your suction cup, opening a slight gap between the back cover and the frame.

  • This may require a significant amount of force, but you only need to open a very slight gap with the suction cup to insert your tool.

  • If you have trouble, apply more heat to further soften the adhesive, and try again. The adhesive cools very fast, so you may need to heat it repeatedly.

  • If you're using an iOpener, follow instructions to avoid overheating it, or the gel pack may burst.

Positioniere einen Saugheber so nah an der erhitzten Kante der Rückabdeckung.

Der Saugheber wird nicht an den abgerundeten Kanten halten - positioniere ihn aber so weit wie möglich an ihnen.

Sollte die Rückabdeckung beschädigt sein, versuche, sie mit starkem Klebeband anzuheben, oder den Saugheber festzukleben und ihn nach dem Trocknen anzuheben.

Hebe die linke Kante der Rückabdeckung leicht mit dem Saugheber an, um zwischen Rückabdeckung und Rahmen einen Spalt zu erzeugen.

Dies erfordert eine gewisse Kraft, aber du brauchst nur einen sehr kleinen Spalt zu schaffen, um das Plektron einzuführen.

Wenn du Probleme damit hast, lass mehr Wärme einwirken, um den Kleber aufzuweichen. Bedenke, dass der Kleber schnell auskühlt, du also recht schnell arbeiten musst.

Wenn du einen iOpener benutzt, folge dieser Anleitung, um eine Überhitzung zu vermeiden, denn sonst könnte das Gelpack platzen.

Vos contributions sont faites dans le cadre de la licence open source Creative Commons.