Aller au contenu principal

Sostituzione vetro posteriore Samsung Galaxy S8+

Info : Vous modifiez un tutoriel prérequis. Toutes les modifications apportées affecteront les 5 tutoriels qui comprennent cette étape.

Anglais
Italien

Traduction de l’étape 3

Étape 3
Samsung Galaxy S8+ Back Glass Replacement: étape 0, image 1 de 2 Samsung Galaxy S8+ Back Glass Replacement: étape 0, image 2 de 2
  • Secure a suction cup to the back cover, as close to the heated edge as possible.

  • The suction cup will not make a good seal on the curved portion of the glass, so avoid putting it on the very edge.

  • If the phone's back cover is cracked, the suction cup may not stick. Try lifting it with strong tape, or superglue the suction cup in place and allow it to cure so you can proceed.

  • Lift the back cover's left edge with your suction cup, opening a slight gap between the back cover and the frame.

  • This may require a significant amount of force, but you only need to open a very slight gap with the suction cup to insert your tool.

  • If you have trouble, apply more heat to further soften the adhesive, and try again. The adhesive cools very fast, so you may need to heat it repeatedly.

  • If you're using an iOpener, follow instructions to avoid overheating it, or the gel pack may burst.

Fissa una ventosa sulla cover posteriore, il più vicino possibile al bordo riscaldato.

La ventosa non aderirà bene sulla parte incurvata del vetro, perciò evita di metterla sul bordo stesso.

Se la cover posteriore del telefono è rotta, la ventosa potrebbe non aderire. Prova a sollevarla con del nastro adesivo tenace o ad incollare la ventosa in posizione con della supercolla (cianoacrilica) e lasciarla poi asciugare prima di procedere.

Solleva il lato sinistro della cover con la ventosa per aprire una piccola fessura fra il case posteriore e il telaio.

Questa azione richiede di applicare una forza abbastanza significativa, ma con la ventosa devi soltanto aprire una fessura molto piccola per inserirci il tuo attrezzo.

Se non riesci, riscalda di nuovo per ammorbidire di più l'adesivo e riprova. L'adesivo si raffredda molto velocemente quindi è probabile che dovrai riscaldarlo più volte.

Se stai usando un iOpener, segui le istruzioni per evitare di surriscaldarlo, altrimenti il pacco di gel potrebbe scoppiare.

Vos contributions sont faites dans le cadre de la licence open source Creative Commons.