Aller au contenu principal

Info : Vous modifiez un tutoriel prérequis. Toutes les modifications apportées affecteront les 12 tutoriels qui comprennent cette étape.

Anglais
Chinois

Traduction de l’étape 1

Étape 1
Before starting this procedure, you should disable your Mac's Auto Boot feature. Auto Boot powers on your Mac when you open the lid, and may be accidentally triggered during disassembly. Use this guide to disable Auto Boot.
Remove the screws securing the lower case
  • Before starting this procedure, you should disable your Mac's Auto Boot feature. Auto Boot powers on your Mac when you open the lid, and may be accidentally triggered during disassembly. Use this guide to disable Auto Boot.

  • If your MacBook is running Big Sur v11.1 or later, disabling Auto Boot may not work. You can proceed normally, but make sure to disconnect the battery as soon as you're inside.

  • Completely power off and unplug your MacBook before you start. Close the display and flip the entire laptop upside-down.

  • Use a P5 driver to remove the following screws:

  • Two 7.9 mm screws

  • Two 7.3 mm screws

  • Six 2.6 mm screws

  • Throughout this repair, keep track of each screw and make sure it goes back exactly where it came from to avoid damaging your MacBook.

在开始此过程之前,你应该禁用 Mac 的自动重启功能。打开盖子时,Mac上的自动重启功能会打开,并且在拆卸过程中可能会意外触发。使用本指南禁用自动重启。

如果你的MacBook运行的是Big Sur v11.1或更高版本,则禁用自动重启可能不起作用。你可以正常进行,但是请确保在进入电池后立即断开电池连接。

开始之前,请完全关闭电源并拔下MacBook的电源。合上显示屏,然后将整个笔记本电脑上下颠倒。

使用P5驱动器卸下以下螺丝:

两颗7.9毫米螺丝

两颗7.3毫米螺丝

六颗2.6毫米螺丝

在整个维修过程中,请密切注意每颗螺丝,并确保其完全从原处返回,以免损坏MacBook。

Vos contributions sont faites dans le cadre de la licence open source Creative Commons.