Aller au contenu principal

Changement coque arrière Samsung Galaxy S21 Plus

Info : Vous modifiez actuellement une condition préalable du tutoriel que vous venez de consulter. Toutes les modifications affecteront les 14 tutoriels qui comprennent cette étape.

Anglais
Français

Traduction de l’étape 2

Étape 2
Samsung Galaxy S21+ Back Cover Replacement, Insert an opening pick: étape 0, image 1 de 3 Samsung Galaxy S21+ Back Cover Replacement, Insert an opening pick: étape 0, image 2 de 3 Samsung Galaxy S21+ Back Cover Replacement, Insert an opening pick: étape 0, image 3 de 3
Insert an opening pick
  • Secure a suction handle to the bottom edge of the back cover, as close to the edge as possible.

  • If the back cover is cracked, the suction handle may not stick. Try lifting it with strong tape, or superglue the suction handle in place and allow it to cure so you can proceed.

  • Lift the back cover with the suction handle to create a small gap between the back cover and the frame.

  • If you have trouble creating a gap, apply more heat to further soften the adhesive. Follow the iOpener instructions to avoid overheating.

  • Insert an opening pick into the gap you created.

  • Slide the opening pick to the bottom left corner to slice the adhesive.

  • Leave the opening pick in place to prevent the adhesive from resealing.

Positionnez une ventouse sur le bas de la coque arrière, aussi près du bord que possible.

Si la coque arrière est fissurée, la ventouse risque de ne pas adhérer. Essayez de la soulever avec un ruban adhésif solide ou bien collez la ventouse avec de la superglue et laissez sécher avant de continuer.

Soulevez la vitre arrière à l'aide de la ventouse afin de créer un petit interstice entre la vitre arrière et le châssis.

Si vous avez du mal à créer cet interstice, appliquez plus de chaleur pour ramollir davantage l'adhésif. Suivez les instructions pour l'iOpener afin d'éviter toute surchauffe.

Insérez un médiator dans l'interstice que vous venez de créer.

Faites glisser le médiator vers le coin inférieur gauche, afin de découper l'adhésif.

Laissez le médiator en place pour éviter que l'adhésif adhère de nouveau.

Vos contributions sont faites dans le cadre de la licence open source Creative Commons.