Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Boutique

Anglais
Chinois

Traduction de l’étape 15

Étape 15
Place one probe at each end of the circuit or component you want to test. It doesn't matter which probe goes where; resistance is non-directional.
  • Place one probe at each end of the circuit or component you want to test.

  • It doesn't matter which probe goes where; resistance is non-directional.

  • If your multimeter reads close to zero, the range is set too high for a good measurement. Turn the dial to a lower setting.

  • If you set the range too low, the multimeter simply reads 1 or OL, indicating that it is overloaded or out of range. This won't hurt the multimeter, but we need to set the dial to a higher range.

  • The other possibility is that the circuit or component you are testing doesn't have continuity—that is, it has infinite resistance. A non continuous circuit will always read 1 or OL on a resistance test.

在两根表笔之间放入您想测试的电路或电子元件。

表笔放置的位置正反无所谓,因为电阻没有方向。

如果万用表的读书是0,那么说明测试区间设置过高。请将旋钮转向低一点的区间。

如果设置的测试范围过低,万用表会显示1或者 OL,表明电路过载或者超过测试范围。此时万用表不会受到损伤,但是我们需要将万用表调到更高的测试区间。

另一种可能性是待测电路或电子元件中间有断路导致电阻无限大。断路也会导致万用表在测试电阻时候显示1或者 OL。

Vos contributions sont faites dans le cadre de la licence open source Creative Commons.