Aller au contenu principal
Anglais
Français

Traduction de l’étape 8

Étape 8
Remove electronic strips on the right, bottom center, top center, and a cable on the left side of the input board. Remove two screws shown in the second image.  Remove the gray connector on top of the input board. Next, use a flat head screwdriver to assist you in prying the right clip while simultaneously pulling up on the input board.  Unclip the component from the logic board.
  • Remove electronic strips on the right, bottom center, top center, and a cable on the left side of the input board.

  • Remove two screws shown in the second image. Remove the gray connector on top of the input board.

  • Next, use a flat head screwdriver to assist you in prying the right clip while simultaneously pulling up on the input board. Unclip the component from the logic board.

  • Note that there is a clip on both the left and right sides of the input board.

Insérez ici votre traduction

Insérez ici votre traduction

Insérez ici votre traduction

Insérez ici votre traduction

Vos contributions sont faites dans le cadre de la licence open source Creative Commons.