Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Pièces & Outils

Anglais
Français

Traduction de l’étape 3

Étape 3
This step is for removing the brake drum and the wheel bearing together. Use a mallet and a flat head screwdriver to make a small indentation along the edge of the wheel bearing dust cap. Pry the dust cap out of the brake drum with the flat head screwdriver.
  • This step is for removing the brake drum and the wheel bearing together.

  • Use a mallet and a flat head screwdriver to make a small indentation along the edge of the wheel bearing dust cap.

  • Pry the dust cap out of the brake drum with the flat head screwdriver.

  • Remove the 29 mm rear hub bolt nut from the brake drum. This will require either a breaker bar or an impact wrench.

  • This nut is torqued to 175 ft-lbs, and should not be removed more than four times. Use a permanent marker to make a mark on the nut each time it is removed.

Insérez ici votre traduction

Insérez ici votre traduction

Insérez ici votre traduction

Insérez ici votre traduction

Insérez ici votre traduction

Vos contributions sont faites dans le cadre de la licence open source Creative Commons.