Réparez vos affaires Communauté Boutique

Reemplazo de la placa lógica del iPad Air LTE

Info : Vous modifiez un tutoriel prérequis. Toutes les modifications apportées affecteront les 2 tutoriels qui comprennent cette étape.

Retourner au tutoriel
Anglais
Espagnol
Étape précédente Étape suivante

Traduction de l’étape 31

Étape 31
iPad Air LTE Logic Board Replacement: étape 0, image 1 de 3 iPad Air LTE Logic Board Replacement: étape 0, image 2 de 3 iPad Air LTE Logic Board Replacement: étape 0, image 3 de 3

  • Remove the battery isolation pick.

  • Insert a plastic card underneath the logic board at the battery connector.

  • Do not use excessive force when inserting this card under the logic board to prevent damaging its battery pins. If the logic board wont budge easily, try reheating the adhesive underneath with an iOpener.

  • As you push through the adhesive at the outer edge of the logic board, be careful not to damage the upper button assembly ribbon cable that you disconnected in Step 60. Position the card exactly as shown.

  • Slide the card all the way underneath the logic board, separating the adhesive along the outer edge.

Retira la púa de aislamiento de la batería.

Inserta una tarjeta de plástico debajo de la placa lógica en el conector de la batería.

No utilices demasiada fuerza al insertar esta tarjeta bajo la placa lógica para evitar dañar las patillas de la batería. Si la placa lógica no se mueve con facilidad, intenta recalentar el adhesivo de debajo con un iOpener.

Al empujar a través del adhesivo en el borde exterior de la tarjeta lógica, ten cuidado de no dañar el cable plano del conjunto de botones superior que desconectó en Paso 60. Coloca la tarjeta exactamente como se muestra.

Desliza la tarjeta hasta el fondo por debajo de la placa lógica, separando el adhesivo a lo largo del borde exterior.

[* black] Remove the battery isolation pick.
-[* black] Insert a plastic card underneath the logic board at the battery connector.
+[* black] Insert a [product|IF145-101|plastic card] underneath the logic board at the battery connector.
[* icon_caution] Do not use excessive force when inserting this card under the logic board to prevent damaging its battery pins. If the logic board wont budge easily, try reheating the adhesive underneath with an iOpener.
[* icon_caution] As you push through the adhesive at the outer edge of the logic board, be careful not to damage the upper button assembly ribbon cable that you disconnected in [guide|63740|Step 60|stepid=134002]. Position the card exactly as shown.
[* black] Slide the card all the way underneath the logic board, separating the adhesive along the outer edge.

Vos contributions sont faites dans le cadre de la licence open source Creative Commons.