Réponses
-
A répondu à : Water DamageI suggest you stop using your MacBook immediately, disconnect the battery and charger until you can clean the logic board. It's a typical story... 1) liquid spill 2) panic 2) Oh, it works! Panic over. 3) it stops working after 2-3 weeks 4) by this time permanently energised power supply areas on the logic board are corroded beyond repair You need to clean your logic board immediately. Good wash in hot water and 24h drying should be OK.
Commentaires du tutoriel
Horaires d'activité
Les horaires où vous avez été actif au cours des 90 derniers jours. Chaque ligne de ce graphique représente une action que vous avez effectuée sur le site (nous comptons seulement les actions principales, comme voter ou modifier un message). Les nombres en bas du graphique sont les heures de la journée au format Mountain Standard Time.
Filtrer l'activité par :
Réputation au fil du temps
Répartition de la réputation
Évènement | Compte | Delta |
---|---|---|
Le message a été promu | 1 | 12 |
Badges
154465
Notifications récentes
Tout marquer comme lu
Show:
Tous
Tous
Non lu(s)
I usually use a piece of sticky transparent office tape and stick it over the flat cable a bit further away from the mating part then pull on it. There is no better way to force the flat cable into a stiff connector without damaging the fragile cable.
Flat cable ZIF socket manufacturers do not recommend using any tools to open or close the retaining flap due to its fragile nature. They recommend using only you fingers! It's in most socket datasheet instructions section.