Aide
Sarr Sheffer
@sheffers
Sarr Sheffer
| 16 | Réputation |
| 0 | Solutions |
| 0 | Tutoriels |
| Membre depuis 06/05/2016 | |
Équipe
Votes
2
0
| 16 | Réputation |
| 0 | Solutions |
| 0 | Tutoriels |
| Membre depuis 06/05/2016 | |
| Évènement | Compte | Delta |
|---|---|---|
| Modification contrôlée d’une étape de tutoriel acceptée | 7 | 7 |
| Quelqu'un a utilisé votre tutoriel | 2 | 6 |
| Modification contrôlée d’une étape de tutoriel acceptée | 2 | 2 |
on reassembly, make sure that the connector cable is back in place, along side the battery, and not up, or on top in any way.
Adhesive may require a tiny amount of tugging of the barometric vent to free it…
In this photo, the holes that are shown in Step 51, where it states, “2018-2019 models: Use a P2 Pentalobe driver to remove both 3.2 mm screws,” are in a different position, so that re-securing the battery board doesn’t seem possible.