Replacing tristar on 6S, knocking resistors off next to itI can’t seem to replace this chip without knocking off those tiny resistors next to it. They’re so small that it’s almost...
820-3115 board- Can I remove Q3880 and U3890 on the logic board?Hey everyone- I’m kind of new to board-level repair. I have an 820-3115 macbook pro board here, it had no power due to...
How do you get the digitizer to stay on the iPad frame when replacing?How do you get the glass on an iPad 3, or any iPad for that matter, to stay on correctly without having any bumps where it...
Réponse à : « Front load washer is making 'brief' thumpingnoise during spin cycle »Does it happen when the spin cycle gets faster? If so, there could be a defect in the drum, or there could be an unbalanced load. Look up how to put your washer in test mode, and then run a spin test with no load. Make it run at maximum speed with no clothes in it first, and if it still vibrates then it's not an unbalanced load. If it does, it could be a problem with the washer. This can also be caused by a washer that is not level or on an uneven surface. Try leveling it by using an adjustable crescent wrench to turn the leveling feet up and down to make it sit level on the surface. Hope this helps.