Introduction

I am first of all doing this to enter to win a PS3 Slim or PSP Go. I am also doing this to find out what's inside this CD player.

Cette vue éclatée n'est pas un tutoriel de réparation. Pour réparer votre Sony CD Walkman D-NF430, utilisez notre manuel de réparation.

  1. Start by looking at the fine detail of the exterior.
    • Start by looking at the fine detail of the exterior.

    Ajouter un commentaire

  2. Open it, remove any CDs and put away. Open the battery cover and remove the battery.
    • Open it, remove any CDs and put away. Open the battery cover and remove the battery.

    Ohh, Black Album.

    Chris Green - Réponse

    • Close the battery cover and locate your screwdriver.

    Ajouter un commentaire

    • Unscrew the six screws and place them on the magnet so you'll be able to find them later. Sony was nice enough to put the screws next to the lid at an angle so you can fit a screwdriver in there.

    Ajouter un commentaire

    • Insert the tip of a screwdriver between the white upper layer and the gray lower layer. Carefully pry apart. There are small clips that help hold the two layers together and you don't want to snap them.

    Ajouter un commentaire

  3. Répandez la magie de Noël
    Obtenez 12 $ de réduction sur les commandes de 50 $ ou plus avec le code FIXMAS12
    Répandez la magie de Noël
    Obtenez 12 $ de réduction sur les commandes de 50 $ ou plus avec le code FIXMAS12
    • Here's the inside of the bottom layer.

    Ajouter un commentaire

    • Now to remove the laser reading assembly. Carefully peel the orange data ribbon off the circuit board to the plug. Using the flat screwdriver, pry the black clip away from the tan part.

    Ajouter un commentaire

    • Now for the power wires. Pry up on the side opposite of the wires.

    Ajouter un commentaire

    • Now for the other side. Carefully peel up the antenna plate so you can get at the other data ribbon.

    Ajouter un commentaire

    • Peel the black tape off the plug. Pry up with a screwdriver on the brown clip and remove the data ribbon.

    Ajouter un commentaire

    • Now for the top layer. unscrew the five screws and place them on the magnet. Pry up on the side indicated to remove the cover.

    Ajouter un commentaire

    • Pull out the circuit board and LCD screen assembly. Pry up on the brown clip to remove the LCD screen.

    Ajouter un commentaire

    • Now you can remove the data ribbon by prying up on the brown clip.

    Ajouter un commentaire

    • To remove the buttons, carefully pry up around the little pins and pull up.

    Ajouter un commentaire

    • You're done! You have taken this CD player apart and broken it down into its individual components. Now to put it back together.

    Ajouter un commentaire

reuse2009

Membre depuis le 22/10/2009

91 Réputation

1 tutoriel rédigé

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 9

30 derniers jours : 41

Total : 13,103