Introduction

This guide will take you through all the steps to sucessfully install a new logic board to your Olympus D590 camera.

Pièces

Aucune pièce nécessaire.

Flip camera so you are looking at the bottom.
  • Flip camera so you are looking at the bottom.

  • Unscrew all 5 base plate screws.

Ajouter un commentaire

Lift open retainer clip by sliding the clip to the left and letting the clip pop up.
  • Lift open retainer clip by sliding the clip to the left and letting the clip pop up.

Ajouter un commentaire

Unscrew the single screw located next to the battery slot.
  • Unscrew the single screw located next to the battery slot.

Ajouter un commentaire

Turn the camera so that the USB, AV and DC in/out rubber plate it facing you.
  • Turn the camera so that the USB, AV and DC in/out rubber plate it facing you.

  • Lift the rubber plate exposing the ports beneath.

Ajouter un commentaire

Kits de RAM Mac
Accélérez votre Mac. Maximisez sa mémoire.
Kits de RAM Mac
Obtenez plus de mémoire sur votre Mac.
Unscrew the 2 screws next to the USB and AC ports.
  • Unscrew the 2 screws next to the USB and AC ports.

Ajouter un commentaire

Use a flathead screwdriver or another flat opening tool to pry the faceplate from the whole device.
  • Use a flathead screwdriver or another flat opening tool to pry the faceplate from the whole device.

Ajouter un commentaire

Pull off the faceplate to reveal the inside of the camera.
  • Pull off the faceplate to reveal the inside of the camera.

  • Be careful of the connector that goes from the faceplate to the motherboard . Disconnecting this line will cause the camera not not power on through the on/off switch anymore.

Ajouter un commentaire

Unscrew all 4 circled screws.
  • Unscrew all 4 circled screws.

Ajouter un commentaire

The logic board should now be loose and easily liftable.
  • The logic board should now be loose and easily liftable.

  • DO NOT lift the board out completely the wiring that is still connected must be disconnected before proceeding.

Ajouter un commentaire

Disconnect the 3 wiring strips from the device by gently pulling with tweasers from the base of the strip. Do not use sharp tweasers because the wiring might tear. Make sure to use small force so the wiring is not damaged.  It may help to gently wiggle the tape.
  • Disconnect the 3 wiring strips from the device by gently pulling with tweasers from the base of the strip.

  • Do not use sharp tweasers because the wiring might tear.

  • Make sure to use small force so the wiring is not damaged. It may help to gently wiggle the tape.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Sara

Membre depuis le 15/04/2010

84 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 28-23, Regan Spring 2010 Membre de l'équipe Cal Poly, Team 28-23, Regan Spring 2010

CPSU-REGAN-S10S28G23

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 1,606