Introduction

Use this guide to replace your PSP Go's top cover.

Unscrew the four Phillips screws on the back of the PSP Go. Rotate the PSP so you can see the top of the device.
  • Unscrew the four Phillips screws on the back of the PSP Go.

  • Rotate the PSP so you can see the top of the device.

  • Unscrew the two Phillips screws next to the volume buttons.

Ajouter un commentaire

Use a plastic opening tool around the perimeter of the back cover to loosen it on all sides. Open the back cover by gently lifting the right side, and rotating it to the left side (as if you were opening a book).
  • Use a plastic opening tool around the perimeter of the back cover to loosen it on all sides.

  • Open the back cover by gently lifting the right side, and rotating it to the left side (as if you were opening a book).

  • Be careful not to rotate the back cover from the bottom, as you will break the plastic screw holes on top of the device.

Ajouter un commentaire

Pull the top cover upwards gently from its housing.
  • Pull the top cover upwards gently from its housing.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 8

Total : 4,902