Réparez vos affaires Communauté Boutique

Le premier modèle d'iPhone, modèle A1203 avec 4 ou 8 Go de stockage, et coque en aluminum. Les réparations sont souvent basées sur le principe du levier et peuvent demander de la soudure quelques fois.

224 questions Voir tout

Options

What to look out for when soldering the battery wires

I've got a iPhone 1st Gen that I'm trying to get the battery changed.

After desoldering the old battery out and soldering the new battery in, the phone wouldn't charge.

When I plug the charging cable in, the apple logo shows for a bit, then disappears. And that's all it'll do.

I know I've got the black cable correctly soldered as there is contact between it and the big metal cover above it.

How do I go about testing the red and white cable if they are soldered in correctly?

Répondre à cette question J'ai le même problème

Cette question est-elle utile ?

Oui Non
Indice -1
Ajouter un commentaire

2 Réponses

Filtrer par :
Les plus utiles Les plus récentes Les plus ancien(ne)s
Réponse la plus utile

Options

Sounds like the boat I just stepped off of.

I had a similar problem when I replaced my battery initially. When I lifted the battery out, the leads just came right off of the communications board. I attempted scraping the first layer of the PCB (lightly) in that spot in order to find traces for the connections. Sadly, if those leads come off it is nigh-impossible to resurrect IMHO. Long story short, my iPhone showed the exact same symptoms as you described (When plugged in, logo would come up and it would look as if the screen lost power and the logo would fade) and the communications board needed to be replaced.

I contacted iFixIt and they did not have the parts required in stock. I did find them through a retailer (LaptopAid) on eBay and their part worked like a charm! A new communications board + presoldered battery was only $45US through them and they have quick shipping.

Hope this helps!

Cette réponse est-elle utile ?

Oui Non
Indice 1
Ajouter un commentaire

Options

I would make sure you have not created a solder bridge (shorted out) between the red and the white wire solder points.

AND make double sure you have not pinched the wires on the shield - I found it hard to rout them properly.

Test it with the back off, making sure the wires are free and not touching anything for starters

Cette réponse est-elle utile ?

Oui Non
Indice 0
Ajouter un commentaire

Ajouter une réponse

riDerz sera éternellement reconnaissant.
Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 3

Total : 1,988