Réparez vos affaires Communauté Boutique

Information and repair instructions for GE Profile Refrigerator

62 questions Voir tout

Options

Refrigerator not cooling and compressor is not running

I have a GE Profile Refrigerator model SPPSS26SHRSS. The refrigerator is not cold and the compressor is not running. 2 days ago the ice and water dispenser stopped working. But the freezer continued to make ice. When I pressed the button for water or ice the green light flashed. When I open the door to the refrigerator the light in side was flashing. Last night I opened the freezer door to get a piece of ice and notice the ice was 1/2 melted. Check the temperature for the freezer it said 35 and the refrigerator was at 57. Emptied out everything from both side. Temperature only increase by 3 degrees. Checked the condenser below the fridge and in back for dust. Vacuumed and very little dusk came out. Tried unplugging the unit and plugging it back in, no change. Can you advise what we should try doing or what parts may need to be replaced.

Répondre à cette question J'ai le même problème

Cette question est-elle utile ?

Oui Non
Indice 0
2 commentaires

my refrigerator was not runnig last day.

par

@hnin - You might want to post a new question and give us your exact symptoms so we can give your question the attention it deserves ;-)

par

Ajouter un commentaire

2 Réponses

Filtrer par :
Les plus utiles Les plus récentes Les plus ancien(ne)s
Réponse la plus utile

Options

Here's a previous question that may give you some insight as to what your issue may be!

Hope this helps, please come back for more assistance if the answer is not resolved.

Why are my fridge and freezer not cooling?

Cette réponse est-elle utile ?

Oui Non
Indice 2
Ajouter un commentaire

Options

if all fans r working, all lights on, just the compressor is not running,

most likely the inverter board--- screw to compressor is bad.

compressor itself may also bad.

to check if the compressor went bad, you need to have multi-meter to measure

the resistance. Unplug the 3-prong plug on the compressor, in general,

all these 3 prong should have the same ohm, if any one pair is 1 ohm less or more,

bad compressor.

Other way to check compressor for ground. connect one prong on compressor with your

meter pin(red or black), another end to metal or copper pipe from the fridge. Meter should Not read

any ohm. any beep or ohm indicates the compressor grounded, need to change.

If compressor is good.

use your multi-meter amp clamp to one of the 120v wire from main board to inverter.

plug that 3-prong plug back to the compressor, power on the fridge,

if meter doesn't show any amp in reading,

the inverter board is bad. it means the board is receiving power but can't send signal to the compressor. Board replacement is needed.

Cette réponse est-elle utile ?

Oui Non
Indice 0
Ajouter un commentaire

Ajouter une réponse

jljabt sera éternellement reconnaissant.
Nombre de vues :

Dernières 24 heures : 1

7 derniers jours : 7

30 derniers jours : 23

Total : 15,583