Réparez vos affaires Communauté Boutique

Le premier modèle d'iPhone, modèle A1203 avec 4 ou 8 Go de stockage, et coque en aluminum. Les réparations sont souvent basées sur le principe du levier et peuvent demander de la soudure quelques fois.

224 questions Voir tout

Options

Can you replace the battery without soldering?

Is there room in the iPhone to simply cut the old wires, strip the end, and then attach the leads to the replacement battery wires? (of course using some heat shrink tubing to insulate the connections.) It shouldn't take up that much extra space, if you judge the lengths correctly. Judging by the photos here, I think there should be enough room.

I read so much about the difficulties of desoldering and soldering on the iPhone board, thought this might be a safer route. Of course, you still need to be careful not to cause a short, etc.

Répondre à cette question J'ai le même problème

Cette question est-elle utile ?

Oui Non
Indice -1
Ajouter un commentaire

3 Réponses

Filtrer par :
Les plus utiles Les plus récentes Les plus ancien(ne)s
Réponse la plus utile

Options

LOL, thanks Louis. I have soldered little connections before, but had read about how difficult this one was- I guess that's all relative. I've done enough iFixit repairs to know I can handle most difficult jobs, but also that I'm better off to take the easiest way possible... ;-)

Cette réponse est-elle utile ?

Oui Non
Indice 1
Ajouter un commentaire

Options

I'm not an expert on soldering, but it seems to me that doing it that way, while it may be easier, creates 3 possible failure points instead of 2 (battery side, logic board side, and then adding a middle solder). With something that gets bumped around that much, it seems scary to me.

Having that said, I believe there may be enough clearance.. steps 18-21 of the guide show sufficient wire length.

Cette réponse est-elle utile ?

Oui Non
Indice 0
Ajouter un commentaire

Options

Solderng is an easy thing to do, but a difficult skill to learn to do properly.

If you're at the point where you'd rather cut and heatshrink wires than learn to solder you shouldn't be working on your own stuff.

Cette réponse est-elle utile ?

Oui Non
Indice 0
Ajouter un commentaire

Ajouter une réponse

madmaxmedia sera éternellement reconnaissant.
Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 1

Total : 4,198