Rep: 25
2
1
My charge port has broken and I have found that the problem is the inside has snapped from overuse. I am not covered by warranty so I need to replace it manually, I purchased a replacement but I dont know how to remove the old one.
Cette question est-elle utile ?
Rep: 2k
6
9
1
Hi Dave,
I assume the charge port you bought was just a port itself, not a flex cable assembly right? I haven't been inside an xperia play so I'm not sure whether it attaches to the main PCB or something else, but I do replace a lot of charge ports. If you bought just the port by itself, then you have quite a task ahead of you. Removing a charge port from a board will require a heat gun and some heat-resistant tape. Installing the new one will require a soldering iron with a very small tip and a microscope or extremely good eyesight. There are many videos out there about this process, but if you have no soldering experience, I wouldn't recommend trying this job as its likely for you to burn/melt the PCB. Take it/ send it off to a professional. Hope this helps
Cette réponse est-elle utile ?
I live in the UK, do you have any recommendations on reliable places to get it replaced?
Unfortunately I don't. I live in the US. Here is a result I found though, they're prices seem reasonable enough: http://www.fonefunshop.co.uk/repairs/cha...
Dernières 24 heures : 0
7 derniers jours : 0
30 derniers jours : 0
Total : 96
