Aller au contenu principal

Deuxième génération de l'iPhone. Modèle A1241 / capacité de 8 ou 16 Go / coque arrière noire ou blanche. La réparation est plus simple que pour l'iPhone de première génération et nécessite des tournevis, des outils pour faire levier et une ventouse.

Questions au sujet de 1212 Voir tout

Direction of power button during asembly

I believe i am doing something wrong as my power button is depressed and won't move after I assembled it. Which direction should the lever on the power button move? One side moves completely flat versus the other side remains slanted

Répondu ! Afficher la réponse J'ai le même problème

Cette question est-elle utile ?

Indice -1
Ajouter un commentaire

6 solutions

Solution retenue

hi birdie,

think i answered this a few days ago.. the silver ring hangs downwards and sits in a little groove on rear case. when you put the screws in make sure not to over tighten them- sounds like you've got one of yours tighter than the other. take button out and try again, if this doesn't work you might have to flip the button round (some have a right side and a wrong side) it's a tricky/fiddly fix and i sometimes do it several times before it finally works. good luck

Cette réponse a-t-elle été utile ?

Indice 2
Ajouter un commentaire

The problem seems to be that is not reaching down and has no support and instead it sunkens down

Cette réponse a-t-elle été utile ?

Indice 0

Commentaires:

try a bit of tape to hold button in while you put screws in

par

Ajouter un commentaire

It sunkens after i\I put the screws in and press the power button down. Any idas?

Cette réponse a-t-elle été utile ?

Indice 0

Commentaires:

Did you replace the rear cover? Your first question was after a drop

Can you post a photo of back case without button in? + with?

par

Ajouter un commentaire

Yes I replaced the back cover, it looks identical to the original. I dont have a camera with me now. What are your thoughts?

Cette réponse a-t-elle été utile ?

Indice 0

Commentaires:

Just wondering if the place where power button fits hasn't been manufactured well enough to house power button. If the groove isn't holding the silver ring maybe this is why it is lopsided and not springing

par

Ajouter un commentaire

I put a piece of tape, the screws and when pushed it still sunkens down. I give up

Cette réponse a-t-elle été utile ?

Indice 0

Commentaires:

have you tried a bit of tape wrapped around the silver ring to push it up a bit in the housing?

par

Ajouter un commentaire

I could try that. I am trying to suspect I was sold the wrong button cause this thing just sits there and it shouldn't be this hard.

Cette réponse a-t-elle été utile ?

Indice 0

Commentaires:

quality of housings and fittings really varies. get back in contact with the supplier. if you bought off ebay then really read their feedback before buying. I've never had as much trouble as your having!!!!!

par

Ajouter un commentaire

Ajouter une réponse

Birdie sera éternellement reconnaissant.
Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 657