Réparez vos affaires Communauté Boutique

Sorti le 19 septembre 2014, cet iPhone avec un écran de 4,7 pouces est une version plus petite de l'iPhone 6 Plus. Identifiables par les numéros de modèle A1549, A1586, et A1589.

4994 questions Voir tout

Options

No backlight after unlock phone (backlight work during boot)

Hi guys,

recently i repaired iPhone 6 water damaged.

I replaced PMIC, after then phone boot but there are not backlight and touch. I replaced:

- backlight IC

- backlight capacitors

- touch ICs - MESON, CUMULUS

- LCD IC - CHESTNUT

Now after press power button, phone boot with backlight and work normal. When i lock phone, LCD goes off, but when i want unlock phone there are not backlight. Touch and LCD work.

My question is:

Where can be problem? It look, backlight driver do not receive ENABLE signal after booting and do not want work.

Can be here problem with

45_AP_TO_PMU_AND_BL_DWI_CLK

45_AP_TO_PMU_AND_BL_DWI_DO

?

For what is there this bus?

Sorry for my bad english :)

Thanks

@refectio

Répondu ! Afficher la réponse J'ai le même problème

Cette question est-elle utile ?

Oui Non
Indice 0
Ajouter un commentaire

2 Réponses

Filtrer par :
Les plus utiles Les plus récentes Les plus ancien(ne)s
Solution retenue

Options

Those two lines are part of the I2C bus. You will want to check them to insure they are not shorted. I would also look at pin B1 of U1502. That is the Hardware Enable pin. I don't know enough about the internal logic of these IC's to say what could be causing this.

Cette réponse est-elle utile ?

Oui Non
Indice 2
Ajouter un commentaire

Options

I fixed so many backlights specially on 6 and 6s. Normally it's filter

But recently I d given iPhone 6s with very low backlight

Checked all caps, filter, diod, coil etc. Everything seemed fine so I changed backlight ic(u2040) no luck

And than I changed main pm ic and problem has gone.

Cette réponse est-elle utile ?

Oui Non
Indice 1

2 commentaires:

How do you know that you must replace PMIC? Should i use multimeter?

par

yes check all the voltage and most importantly recistance of the components.

But you said you have changed it didn't you?

But again your phone is the water damage. Could be anything man.

Have you checked any short?

par

Ajouter un commentaire

Ajouter une réponse

Tomas sera éternellement reconnaissant.
Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 474