Our dishwasher has stopped washing our dishes. When I start a wash cycle, it seems to start, I can hear water, and then it just stops. On the panel it looks as though the cycle is continuing, but nothing is happening. Error codes E2 F8.
I ran a diagnostic test last night and the errors were displaying as follows:
F6-E6
F7-E1
F8-E2
Cette question est-elle utile ?
Rep: 685,4k
3,4k
1,1k
2,6k
Whirlpool dishwasher error code e2 f2, means main control board is not getting correct signal from the user interface. Turn off power/breaker, remove screws holding inner door liner, remove liner and check/secure/clean all wire connections from front interface and main control board
Cette réponse est-elle utile ?
Thank you for responding, I ran the diagnostic test again last night because I thought I was missing something. These are all of the codes that came up on the screen
F6-E6
F7-E1
F8-E2
Sounds like it may be thirsty. Make sure the water inlet valve is open and that water is flowing.
Whirlpool Dishwasher Fault Code F6
The fault occurs when the dishwasher does not detect any incoming water despite the water inlet valve being open
Whirlpool Dishwasher Fault Code F7
Fault with flow meter detected
Whirlpool Dishwasher Fault Code F8
Water Turbidity Fault
My whirlpool dishwasher is doing everything BUT the wash cycle. Help what do I do? I have already cleaned all filters and reset the circuit breaker.
Cette réponse est-elle utile ?
Dernières 24 heures : 1
7 derniers jours : 7
30 derniers jours : 21
Total : 5,306
