my dsi’s top lcd was inverted, so I was going to do a replacement. i took it apart, but wanted to make sure it still worked, so I turned it on, still half apart. turns out it was a loose cable, so it was fixed! I had to mess aroung with one of the other cables while fully assembling, and got it together and- nope. dead. tried everything. got any ideas?
Cette question est-elle utile ?
Rep: 377
4
2
Hello
With a nds (i think it should be the same with dsi) , if wifi module isn’t correctly connected then the console is not booting. Make sure the connector is correctly fit and that you didn’t damage any pin.
good luck
Cette réponse est-elle utile ?
What would I do if I did damage a pin?
Also, there is a very tiny cord at the top I had a hard time putting back in. Could that be causing it? Thank you very much!
Dernières 24 heures : 0
7 derniers jours : 0
30 derniers jours : 1
Total : 83
