My X360 controller somehow doesn’t have the plug where the rumble motors should plug in, and instead it’s just red and black cables soldered in.
It’s quite old so the cable was torn off and I don’t know where they were soldered in originally.
Where to solder the cables for the motor?
Cette question est-elle utile ?
Rep: 1,8k
4
3
here ya go. https://imgur.com/a/IbLZIoJ
This is the front side of the board, but all you need to do is flip it. the square pad is the black wire and the red is the round pad right next to it.
Cette réponse est-elle utile ?
Dernières 24 heures : 0
7 derniers jours : 1
30 derniers jours : 3
Total : 130
