Rep: 1
1
When I lift screen above about 30-40 degrees it dims so that it
can only be read by straining. If kept below above degrees it is normal but basically unusable. It also works fine with an external monitor.
Any help would be greatly appreciated.
bbaker
Cette question est-elle utile ?
Rep: 37,6k
315
66
72
Your PB inverter cable should be replaced. The cable is probably damaged in the display hinge and loose contact when moving the lid. Don't wait too long to do the repair cause the cable could short in the hinge and ruin your logic board.
Here's the part you need:
[produit lié absent ou désactivé : IF155-051]
Cette réponse est-elle utile ?
Dernières 24 heures : 0
7 derniers jours : 4
30 derniers jours : 4
Total : 552
