I just recently replaced the back glass for my S8 because the old one was cracked. However, the new glass isn't fully adhering to the frame. After applying pressure, a small gap remains on the long sides between the back glass and the phone. How can I make sure the back glass fully sticks?
Cette question est-elle utile ?
Rep: 2,4k
6
1
1
did you cleaned and replaced the adhesive too?
Cette réponse est-elle utile ?
Yes, I cleaned off the previous adhesive and then used a new one.
Is your battery flat? a expanded battery can push out your glass, also a
bent housing can affect.
The battery was flat and the housing was also flat.
Rep: 167
4
2
1
It could be low quality adhesive. I recommend using 3mm adhesive, not the premade stuff. I also recommend to put a soft rag over the phone and leave about 10 to 15 pounds of weight on top of the phone for about 2 hours. I use 3 five pound weights that were previously used for dumbells. Hope this helps.
Cette réponse est-elle utile ?
Dernières 24 heures : 0
7 derniers jours : 0
30 derniers jours : 6
Total : 322
