O2 calibration with new sensor won´t update O2 sensor alarm message


I´ve trying to perform several O2 calibrations with a new sensor Max-16HT, however upon correct completion and saving the calibration the O2 sensor alarm message is still displayed on the left corner of the status bar, showing “O2 Sensor.” After that I tried performing a series of VVT’s but the only failure in this test is O2 100% (Failed), everything else is showing the result OK.

Block Image

Any clues or ideas on what may be happening will be greatly appreciated.



Répondre à cette question J'ai le même problème

Cette question est-elle utile ?

Indice 0
Ajouter un commentaire