Réparez vos affaires Communauté Boutique

Sorti le 25 septembre 2015. Modèle A1687/A1634. La réparation de ce modèle est similaire à celle des versions précédentes et nécessite tournevis et outils pour faire levier. Disponible en GSM et CDMA / 16, 64 ou 128 Go / Argent, Or, Gris sidéral ou Or rosé.

1043 questions Voir tout

Options

No audio No Vibrate

I replaced the battery and lightening-headphone Jack. Worked for awhile then No speaker output for incoming ringtone. No vibration either.

Screen shows caller ID upon receiving a call and the Volume controls are active onscreen just as they should be. The Mute switch toggles as it should and also appears on the screen.

I get ringtones and notifications if I’m linked to my Nyne Bluetooth speaker or my car Sony deck

I have sound if my earbuds are plugged in as well

Are the audio and vibrate lines contained on the same buss? Help me out

Marcus

Répondre à cette question J'ai le même problème

Cette question est-elle utile ?

Oui Non
Indice 0

1 commentaire:

Allan

I’m new to the forum so I hope you see this. I posted an answer vs. comment. Newbie forum Jedi

par

Ajouter un commentaire

3 Réponses

Filtrer par :
Les plus utiles Les plus récentes Les plus ancien(ne)s

Options

It's either the connections for the charging port or a defective charging port. The tapic engine and speaker are powered through the charging port connector/lightning connector.

Cette réponse est-elle utile ?

Oui Non
Indice 0
Ajouter un commentaire

Options

Sweet. I had a strong hunch that one of the flex cable/connector buses that were separated during disassembly didn’t seat correctly and lost continuity.

I recall also also having difficulty with reassembling a few injection molded structural support parts (Tiny!!) That fit next to the charging port. Had an Itty bitty gasket and I don’t recall the rest other than it being totally frustrating and cheeky

Don’t know if that affected my current sitrep.

So does cracking it back open and reseating connectors then opcheck sound about right?

Many suggestions on links for visual references of the target (buss) connectors?

Appreciate ya Brother

marcus

Cette réponse est-elle utile ?

Oui Non
Indice 0

2 commentaires:

I would try checking the connections for damaged pins with a magnifying glass and then clean the the connector with a qtip and alcohol and a soft brush

par

The same issue happened to me. I removed the speaker, scratched the contacts under it, then reinstalled it. It seems to have fixed it.

par

Ajouter un commentaire

Options

I had the exact same issue after replacing the battery, no vibration or sound. Turns out the connector next to the battery connector wasn’t seated properly and just needed pressed down on.

Cette réponse est-elle utile ?

Oui Non
Indice 0
Ajouter un commentaire

Ajouter une réponse

MARK KESLER sera éternellement reconnaissant.
Nombre de vues :

Dernières 24 heures : 2

7 derniers jours : 2

30 derniers jours : 3

Total : 147