Rep: 49
2
2
Please do me a favor to guide me how to replace HDD on HDD Box External Buffalo MiniStation (2,5" - USB 2.0). I 'd like to replace the HDD inside that box. This is the link of product, it's quite hard to open (no screws +_+):
http://www.buffalo-technology.com/produc...
Pls help me ASAP. ^^
Thank you so much in advance
I love your site ^^
Cette question est-elle utile ?
Rep: 78,2k
385
96
162
I can find no information on dis-assembly of this unit. Looking at the photo of the unit it appears there is a seam going around it. You might try using a Spudger to go around that seam to see if that gives you access to the drive for replacement. Good luck.
Cette réponse est-elle utile ?
Thanks for your answer,
I think so, but actually I'm afraid my outside box will be damaged.
Should I take some photos close up to all of my device's sides and show to you to get an advice?
Have a nice day! ^^
You could call the maker and ask for service. Ask them how to open the device. As I said I could find no information on procedures for replacing the drive--I think they may want you to pay them to do it. There is always risk in trying a procedure like opening a case--you have to decide if its worth the risk to you.
Rep: 685,3k
3,4k
1,1k
2,6k
Rep: 418
8
2
1
I made a guide for this, hope it helps.
Démontage du disque dur externe Buffalo MiniStation (Thunderbolt et USB 3)
Cette réponse est-elle utile ?
Rep: 49
2
2
Thanks guys, Actually, I bought this device in Korea and there is no official reseller or global warranty in Vietnam for it! +_+ So, I will leave this topic open and welcome all the ideas coming before I break it up! ^^
Cette réponse est-elle utile ?
just put an ATM card inside the edge, then lift it up slowly, starting from the long edge!
Cette réponse est-elle utile ?
Dernières 24 heures : 0
7 derniers jours : 0
30 derniers jours : 2
Total : 5,496
4 commentaires
Please, anyone? +_+
par quangtrungdesigner
I need helpppppppp +_+
par quangtrungdesigner
This question was migrated from http://meta.ifixit.com/Answers.
par iRobot
I still need your help! +_+
After few weeks, I'm still waiting for a solution! +_+
par quangtrungdesigner