Réparez vos affaires Communauté Boutique

Mis sur le marché le 21 septembre 2018. Modèles A1920, A2097, A2098, A2100. Disponible avec GSM ou CDMA / eSIM ou dual-sim / 64, 256 ou 512 Go / Argent, Or ou Gris sidéral. (Se prononce "iPhone 10 S".)

398 questions Voir tout

Options

Attempting to restore always fails (error 4013)

I disconnected every single sensor, only left battery and dock (USB) port sensors connected.

My device by default already always goes into "Recovery Mode". From there using iTunes or 3UTools, as soon as I select a firmware or backup and click on "Restore" system boots into "installing update/firmware mode", I see the spinning wheel for 2-3 seconds and then system boots back again into Recovery Mode and obviously no update gets installed and nothing works. What am I missing?

Répondu ! Afficher la réponse J'ai le même problème

Cette question est-elle utile ?

Oui Non
Indice 0
Ajouter un commentaire

1 Réponse

Filtrer par :
Les plus utiles Les plus récentes Les plus ancien(ne)s
Solution retenue

Options

This is most likely a hardware fault. The CPU cannot communicate with the NAND it could be a faulty CPU or faulty NAND most likely the latter. The repair would be expensive and only viable if the data needed to be recovered.

Cette réponse est-elle utile ?

Oui Non
Indice 1

1 commentaire:

@itestandroid yeah that's rough Chris is likely right. Your NAND chips have likely got some kind of false data that has corrupted it all.

Did this just randomly happen or did something (EG a surge in voltage or an overnight update) lead to this. I have an Apple watch S4 that had software corruption but a secret trick has brought it back to life.

par

Ajouter un commentaire

Ajouter une réponse

iTest sera éternellement reconnaissant.
Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 2

Total : 321