That connector is the IR sensor connector. On the front there is both a White LED and this IR sensor.
Review Step 13 in this guide [guide|6421] there should be a cable hanging in that corner of the shell with the Black, Red & White wires
-
If you snapped it off the logic board you might be able to re-solder it on as long at the pads are still present and not torn off. Even if they are someone with good skills can patch things together by adding jumper wires to replace the pads.
+
If you snapped it off the logic board you might be able to re-solder it on as long at the pads are still present and not torn off. Even if they are, someone with good skills can patch things together by adding jumper wires to replace the pads.
That connector is the IR sensor connector. On the front there is both a White LED and this IR sensor.
-
Review Step 13 in this guide [guide|6421] there should be a cable hanging in that corner of the shell with the Black, Red & White wires.
+
Review Step 13 in this guide [guide|6421] there should be a cable hanging in that corner of the shell with the Black, Red & White wires
+
+
If you snapped it off the logic board you might be able to re-solder it on as long at the pads are still present and not torn off. Even if they are someone with good skills can patch things together by adding jumper wires to replace the pads.
That connector is the IR sensor connector. On the front is both a LED and this sensor.
Review Step 13 in this guide [guide|6421] there should be a cable hanging in that corner of the shell with the Black, Red & White wires.